NHTSA lists 1 complaints for the 2005 Hino NC6J, 0 of them mention a crash and 0 mention a fire. 0 complaints mention an injury, with 0 injuries and 0 deaths reported.
Data build 2026-10-09.
NHTSA lists this vehicle as HINO NC6J.
Model-generated complaint tags: This model year has not been tagged.
Recalls
See new recalls and investigations this week.
7 recalls.
Date: 2012-12-03. Systems: ELECTRICAL SYSTEM.
Defect: Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing (excerpt)
Consequence: If the B+ circuit shorts to ground, it may lead to a fire. (excerpt)
Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390. (excerpt)
Do not drive: No. Park outside: No.
Date: 2008-04-30. Systems: SUSPENSION.
Defect: HINO IS RECALLING 16,805 MY 2005-2008 NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, AND NV8J TRUCKS. THE TWO VERTICAL RIGHT/LEFT SIDE FRONT SPRING BRACKET BOLTS WERE NOT TIGHTENED PROPERLY DURING THE ASSEMBLY PROCESS. THIS MAY CAUSE INCREASED STRESS ON THE SPRING BRACKET WHICH CAN LEAD TO CRACKING OF THE BRACKET.
Consequence: THIS COULD REDUCE STEERING CONTROL INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE VERTICAL FRONT SPRING BRACKET ATTACHMENT BOLTS ON RIGHT/LEFT HANGER BRACKETS AND RE-TORQUE ALL ASSOCIATED BOLTS FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 8, 2008. OWNERS MAY CONTACT HINO AT 248-699-9300.
Do not drive: No. Park outside: No.
Date: 2006-05-18. Systems: STEERING.
Defect: ON CERTAIN TRUCKS, DURING ASSEMBLY, THE DRAG LINK ATTACHMENT NUTS AT THE PITMAN ARM AND STEERING ARM MAY HAVE BEEN INCORRECTLY TORQUED. RESIDUAL GREASE AND PAINT WHICH WAS APPLIED AS A RUST INHIBITOR ON THE STEERING ARM MAY HAVE CONTRIBUTED TO A LOSS OF TORQUE AFTER ASSEMBLY.
Consequence: INCREASED WEAR FOR THE DRAGLINK CONNECTIONS CAN OCCUR CREATING A NOTICEABLE INCREASE IN THE AMOUNT OF STEERING WHEEL FREE PLAY. IF THIS CONDITION WAS IGNORED, A LOSS OF STEERING CONTROL OF THE VEHICLE COULD OCCUR WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL INSPECT THE STEERING ARM TIGHTNESS AND REMOVE ALL GREASE AND PAINT FROM THE STEERING ARMS AND RETORQUE THE DRAGLINK ATTACHMENT NUTS AT THE STEERING ARM AND PITMAN ARM. THE RECALL BEGAN ON MAY 12, 2006. OWNERS MAY CONTACT HINO AT 1-248-648-6430.
Do not drive: No. Park outside: No.
Date: 2004-09-20. Systems: STEERING.
Defect: ON CERTAIN TRUCKS, WHEN THE STEERING WHEEL IS BEING TURNED, THE DUST COVER MAY TWINE WITH THE STEERING SHAFT AND COULD RESULT IN THE STEERING WHEEL OPERATION BECOMING HEAVY.
Consequence: LOSS OF STEERING CONTROL MAY OCCUR, WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL REMOVE THE OLD DUST COVER AND INSTALL A NEWLY DESIGNED COVER. THE RECALL BEGAN OCTOBER 8, 2004. OWNERS SHOULD CONTACT HINO AT 1-845-365-1400.
Do not drive: No. Park outside: No.
Date: 2004-09-13. Systems: VEHICLE SPEED CONTROL.
Defect: ON CERTAIN CAB AND CHASSIS TRUCKS, WHEN EXCESSIVE FORCE IS APPLIED TO THE ACCELERATOR PEDAL, BEYOND THAT REQUIRED TO ACHIEVE FULL ACCELERATION, THE PEDAL MAY BECOME WEDGED BETWEEN THE FLOOR PANEL AND THE CARPET.
Consequence: WHEN THIS OCCURS, THE ACCELERATOR PEDAL WILL BECOME WEDGED IN THE FULL THROTTLE POSITION WHICH COULD RESULT IN A CRASH WITHOUT WARNING.
Remedy: DEALERS WILL INSPECT THE ACCELERATOR PEDAL HEIGHT TO DETERMINE IF IT IS WITHIN SPECIFICATIONS. IF EITHER THE PEDAL HEIGHT OR THE ACCELERATOR ROD IS NOT WITHIN SPECIFICATIONS, REPLACE THE ACCELERATOR ASSEMBLY. IN ADDITION, A NEW BRACKET CONTAINING AN ACCELERATOR PEDAL STOPPER WILL BE INSTALLED. THE RECALL BEGAN ON SEPTEMBER 8, 2004. OWNERS SHOULD CONTACT HINO CUSTOMER SERVICE AT 1-845-365-1400.
Do not drive: No. Park outside: No.
Date: 2004-04-28. Systems: STEERING.
Defect: ON CERTAIN TRUCKS, THE PINCH BOLT NUT OF THE YOKE CONNECTING THE STEERING GEARBOX AND THE STEERING WHEEL SHAFT BACKED OUT.
Consequence: THIS COULD CAUSE THE YOKE AND THE STEERING WHEEL SHAFT TO SEPARATE WHICH COULD RESULT IN LOSS OF STEERING INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND RETORQUE THE PINCH BOLT NUT AS NECESSARY. OWNER NOTIFICATION BEGAN MAY 7, 2004. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HINO AT 1-845-365-1400.
Do not drive: No. Park outside: No.
Date: 2004-02-25. Systems: EXTERIOR LIGHTING.
Defect: CERTAIN TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." A REVERSE BACKUP SWITCH MAY HAVE BEEN CONTAMINATED DURING THE MANUFACTURING PROCESS. THE NEUTRAL SAFETY SWITCH MAY NOT ALLOW THE CRUISE CONTROL TO ENGAGE.
Consequence: THIS DOES NOT MEET THE REQUIREMENTS OF THE STANDARD. ALSO, THIS COULD CAUSE THE CRUISE CONTROL NOT TO BE ACTIVATED. THE REVERSE BACKUP LIGHT AND BUZZER STAYS ON.
Remedy: DEALERS WILL REPLACE THE SWITCHES. OWNER NOTIFICATION BEGAN ON APRIL 19, 2004. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HINO AT 1-845-365-1400.
Do not drive: No. Park outside: No.
Manufacturer communications
57 manufacturer communications.
Communications by system| System | Count |
|---|
| EQUIPMENT | 16 |
|---|
| ENGINE AND ENGINE COOLING | 14 |
|---|
| POWER TRAIN | 6 |
|---|
| EQUIPMENT ADAPTIVE/MOBILITY | 5 |
|---|
| FUEL SYSTEM, GASOLINE | 4 |
|---|
| FUEL SYSTEM, OTHER | 4 |
|---|
| SUSPENSION | 4 |
|---|
| WHEELS | 4 |
|---|
11000897
Date: 2024-05-17. Type: Service Bulletin/Repair Instructions. Systems: UNKNOWN OR OTHER.
After connecting to a truck using DX3, it may be necessary to review or create a DX Diagnostic Report for review.
11000898
Date: 2024-05-15. Type: Service Bulletin/Repair Instructions. Systems: UNKNOWN OR OTHER.
This article will provide dealership technicians with information on how to open a tech assist case and discuss what is required when opening a Tech Assist Case.
10116051
Date: 2016-09-28. Type: Service Bulletin/Repair Instructions. Systems: ELECTRICAL SYSTEM, EQUIPMENT, TIRES.
SB - 05 - 004 SPEEDOMETER RECALIBRATION. This document is to inform of the procedure to calibrate the Pulse Adjust Module whenneeded (ex. tire size change, rear carrier ratio change).
10116030
Date: 2016-03-22. Type: Service Bulletin/Repair Instructions. Systems: ENGINE, FUEL SYSTEM, GASOLINE.
13-008 Injection Pump Drive Case. Please note the following part number changes to the Injection Pump Bearing Case. Not replacing the correct replacement parts WILL result in major engine damage. The Hino Ordering system has been modified to make the below changes into a kit that consist of the cor
10118109
Date: 2015-06-22. Type: Service Bulletin/Repair Instructions. Systems: STRUCTURE.
TT-15-016 The purpose of this publication is to communicate the standard measuring positions on the Hino chassis. In some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards the driver side or passenger side. The following publication
10117680
Date: 2015-06-02. Type: Service Bulletin/Repair Instructions. Systems: ENGINE AND ENGINE COOLING.
SB-15-026 A subject vehicle may exhibit an engine oil leak or engine coolant leaking externally from the engine head gasket sealing area on the exhaust manifold side of the engine. An improved head gasket has been made available as a service part and should be used if replacement of the head gasket
10118099
Date: 2015-04-13. Type: Service Bulletin/Repair Instructions. Systems: EQUIPMENT.
SB-13-009 This bulletin is to inform dealers and workshops of proper paint codes for all Hino models. ALL MODELS
10117666
Date: 2015-01-22. Type: Service Bulletin/Repair Instructions. Systems: ELECTRICAL SYSTEM.
SB-15-009 This bulletin provides the corrective action for a fluid overflow condition from the main housing breather at startup in cold ambient temperatures at or below +5F (-15C).
10117655
Date: 2014-03-28. Type: Service Bulletin/Repair Instructions. Systems: EQUIPMENT.
SB-14-003 The following is to inform you of the revision of the inspection procedure for the DTC?s P0340 and P0341. You are kindly requested to attach this service data to the relevant pages of the workshop manuals for maintenance and to use for servicing.
10118094
Date: 2013-07-23. Type: Service Bulletin/Repair Instructions. Systems: POWER TRAIN.
13-008 Design Change of the Idler Gear Case and Idler Gear Bolt. Abnormal load such as a stuck supply pump was applied to gear train then causing the bolt to loosen. Therefore, an enhancement to the case and bolt were carried out. The idler gear case and bolt were changed to increase the robustness